Flight controller + ESC – SucceX-D Mini F7 TwinG Stack (Mini F7 + 40A ESC)

The SucceX-D Mini F7 is designed to work seamlessly with DJI’s new HD FPV system. To make things even simpler, the DJI Air module can simply be plugged into the FC with the wiring harness included. In addition, we have added the popular and reliable USB Type-C instead of Micro USB and therefore the same standard as your DJI module.

But the real magic of this flight controller lies in its TWIN GYRO configuration.

TwinG uses two identical gyroscopes oriented next to each other with a 90 degree offset from each other. Betaflight uses GYRO FUSION to combine and average the information from the two gyroscopes to send a much clearer signal to the PID loop controller! Less noise and less vibration in the throttle without adding delay! Betaflight software filters can be lowered in most cases, which significantly reduces latency.

With plenty of processing power and UARTS, it is also the perfect flight controller for long-term GPS construction. And the TwinG configuration makes it the ideal FC for compilations such as macro squares, cinematic shooting platforms and x-class racers that are a little more complicated to set up.

FC // SucceX-D Mini F7

MCU: 216MHz STM32F722
Gyroscope: 2x ICM20689
Blackbox: 32MB
OSD Betaflight: YES
BEC: 5V 2.5A / 9V 2.5A
Current sensor scale: 100
Inverter for SBUS input (UART2-RX)
VART protocol supported Smartaudio & Tramp
support: Bi support: Yes
Pad for RSSI input: No
UARTs: 5
Motor outputs: 4
8-pin 4in1 ESC port (GND, VBAT, M1, M2, M3, M4, CUR, R5)
6-pin DJI Air Unit port (R1, GND , R2, T2, GND, 9V)
BLHeli32 Telemetry: RX5
Input voltage: recommended 2-6S, MAX 6S
Firmware Purpose: IFLIGHT_F722_TWING Mounting
Model: 20 * 20 mm φ3
Dimensions: 29 * 29mm
USB Type-C

ESC // SucceX 40A

MCU: STM32F051K66
Up tp 48kHz PWM frequency
Capacity: 470uF / 50V
Current sensor: Yes
Input: recommended 2-6S
Constant: 40A / Burst: 50A
BlHeli32 telemetry: Yes
Supports up to Dshot1200, Proshot, Oneshot, Multishot
Target: 4IN1
Weight: 7.2g
Mounting model: 20 * 20 mm φ3 mm with Grommets φ2 mm
Dimensions: 31 * 31 mm (including power pads)